Recommended
Parallax Propeller QuickStart
1630-PLX-9951121
In Stock
$44.29 CAD
SparkFun Block for Intel® Edison - Console
1390-SPF-0700217
In Stock
$18.99 CAD
Parallax Propeller Board of Education
1624-PLX-9971173
In Stock
$164.39 CAD
Intel® Edison
1386-INT-9922891
Out Of Stock
$75.89 CAD
Parallax Propeller Project Board USB
1623-PLX-9951123
In Stock
$31.59 CAD

This product is no longer available for sale in our catalog. This page is made available for reference only.

Pimoroni Propeller HAT Board for Raspberry Pi

Pimoroni Propeller HAT Board for Raspberry Pi
Pimoroni Propeller HAT Board for Raspberry Pi Pimoroni Propeller HAT Board for Raspberry Pi Pimoroni Propeller HAT Board for Raspberry Pi
Product ID: 1615-PMR
Manufacturer: Pimoroni
Mfr Parts No.: 32230
Availability: Unavailable

Bring the powerful multiprocessing capability of the Parallax Propeller multicore microcontroller to your Raspberry Pi with the Propeller HAT!

What is a HAT? HAT stands for Hardware Added on Top. Once assembled (yes, soldering is required), this Propeller development board fits snugly on top of your Raspberry Pi, adding all of the awesome features of the Propeller microcontroller without adding a lot of bulk or complexity. What can it do? That's entirely up to you. Run servos, control robotics, create a home automation device, drive VGA – be as creative as you want! There's a breadboard area for easy prototyping and female headers for Propeller I/O pin access.

For Spin programming, you can run PropellerIDE right on your Raspberry Pi. Tutorials and projects for getting started are available via the Pimoroni Propeller HAT Projects portal.  You can also explore the Propeller HAT GitHub Repository documentation for different ways this hardware pair can play together, such as using Python libraries to flash your HAT with a serial GPIO, I2C, or PWM driver.  See the Additional Resources section below for links.

Key Features:

  • Fits right on top of your Raspberry Pi
  • Controlled by the onboard 8-core Propeller microcontroller
  • Onboard breadboard for prototyping
  • Program on the RPi with existing Spin tools
  • Fully open source

Note: This kit comes unassembled. Soldering is required. 

Caution: You will need to make sure that the solder joints on the underside of the HAT do not make contact with the HDMI connector on the Raspberry Pi.  Most Raspberry Pi cases take care of this. Or, you may wish to put a small piece of foam tape over the HDMI connector.  A set of 2 brass standoffs are also included with the kit; if you choose to use these, be sure to press the HAT down on the Raspberry Pi pins all the way.

Technical Details:

  • 8-core Propeller P8X32A-Q44 microcontroller
  • 6 MHz crystal oscillator
  • 3.3 V 300 mA voltage regulator
  • 17 x 10 breadboard with 0.1" spacing
  • EEPROM for Raspberry Pi compatibility
  • PCB Dimensions: in (6.5 x 5.6 cm)

Write a review

Your Name:


Your Review:
Note:

Rating:  Bad             Good

Enter the code in the box below:



Related Products
Raspberry Pi 3 Model B (1.2 GHz Quad Core 64-bit 1GB RAM)
1856-RBP-7814011
In Stock
$53.99 CAD